JDM 1994 2001 HONDA B18C GSR ENGINE. GSR ENGINE, B16B PISTON, TYPE R OIL PUMP, CRANK BEARING AND ROD ACL, CAM GEAR SKUNK2, INTAKE SKUNK 2 PREMIER GEN, THROTTLE TYPE R, HEADER PLM, BELT GATES BLEU. All other parts attach to the motor as seen on the picture. All our JDM Engines and Transmissions are tested before removal from their donor vehicle. All of our engines are pulled from running cars in Japan.
All our JDM engines are imported directly from our own warehouse in Japan, and we pick the most cleanest and low mileage motors possible. All internal engine parts including: pistons, piston rings, piston pins, crankshaft and main bearings, connecting rods and rod bearings, camshaft and camshaft bearings, timing chain and timing gears, intake and exhaust valves, valve springs, seals, guides, oil pump, push rods, rocker arms and shafts. The engine block, cylinder walls and cylinder head are also warranted to be free of cracks or distortion. Head gasket are warranted for 30 days. All external parts attached to the engines e.
G, emission control devices, flywheel, clutch and pressure plate, water pump, thermostat, oil pump, belts, hoses, oil pan, valve cover, sensors, electronic partsdistributor, wires, injectors, etc. The cost of labor required to remove and install a repaired or exchanged engine to the vehicle. Before purchasing the engine, the customer must verify that the engine will fit into said vehicle. We are not responsible for the failure of emissions and smog tests. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts & Accessories\Engines & Engine Parts\Engines".
The seller is "jdm_planet" and is located in this country: CA. This item can be shipped worldwide.